Wilo -Flumen OPTI-TR 22 Instrucciones De Instalación Y Funcionamiento página 23

2
±0°
8
Fig. 6: Swivel the mixer over the basin
1
2
Fig. 7: Mixer on the lowering device
Installation and operating instructions Wilo-Flumen OPTI-TR 20-1, 22, 28-1, 30-1, 40-1, Wilo-Flumen EXCEL-TRE 20, 30, 40
Installation and electrical connection
Lift the mixer and swivel it over the basin
1 Hoist
1
2 Lifting equipment
6 Frame
8 Guide pipe for lowering device
‡
Preparatory tasks completed.
1. Lift mixer so that it can be swiveled safely over the railings.
NOTICE! The mixer must hang horizontal to the hoist. If the mixer hangs at an angle
6
to the hoist, adjust the attachment point on the frame.
2. Swivel the mixer over the basin.
NOTICE! The frame must be perpendicular to the guide pipe. If the frame is not per-
pendicular to the guide pipe, adjust the reach of the hoist.
Mounting the mixer on the lowering device
1 Hoist
2 Lifting equipment
6 Frame
8 Guide pipe for lowering device
6
9
9 Upper holder of the lowering device
‡
Mixer hangs horizontally.
‡
Frame perpendicular to the guide pipe.
‡
Cable bracket is installed.
1. Slowly lower the mixer.
2. Insert the guide pipe in the frame without tilting.
8 NOTICE! The guide rollers are in contact with the guide pipe.
3. Version with quick-release axles:
Lower the mixer until the frame is below the upper holder. Install the quick-release
axles and plastic rollers and secure them with linchpins!
en-US
23