Wilo -Flumen OPTI-TR 22 Instrucciones De Instalación Y Funcionamiento página 33

8.4.1 Ground and wall fixation
8.4.2 Using a lowering device
Installation and operating instructions Wilo-Flumen OPTI-TR 20-1, 22, 28-1, 30-1, 40-1, Wilo-Flumen EXCEL-TRE 20, 30, 40
Decommissioning/removal
DANGER
Risk of fatal injury due to dangerous lone working practices!
Working in pump chambers and tight spaces as well as working where there is a danger
of falling is dangerous work. This work must not be carried out alone!
• Only carry out work with another person!
WARNING
Risk of burns due to hot surfaces!
The motor can get hot during operation. This can lead to burns.
• Allow the motor to cool down to ambient temperature after switching it off!
Wear the following protective equipment while performing the work:
ƒ
Safety shoes: Protection class S1 (uvex 1 sport S1)
ƒ
Protective gloves: 4X42C (uvex C500)
ƒ
Wear a safety harness where required!
ƒ
Safety helmet: EN 397 Conforms to standards, protection against lateral deformation
(uvex pheos)
(When using lifting equipment)
If contact with hazardous fluid occurs during work, wear the following additional protective
equipment:
ƒ
Safety goggles: uvex skyguard NT
–
Labelling frame: W 166 34 F CE
–
Labelling disc: 0-0.0* W1 FKN CE
ƒ
Breathing protection: Half mask 3M series 6000 with filter 6055 A2
The protective equipment specified is the minimum requirement. Observe the specifications
of the work regulations!
* Protection level according to EN 170 not relevant for this work.
‡
Mixer decommissioned.
‡
Operating space emptied, cleaned and, if required, disinfected.
‡
Mixer cleaned and, if required, disinfected.
‡
Ensure work is carried out by two persons.
1. Disconnect mixer from power supply.
2. Disconnect and wind up the connection cable.
3. Enter the operating space. DANGER! If the operating space cannot be cleaned and
disinfected, wear protective equipment according to the work regulations!
4. Uninstall mixer from the basin wall or the basin floor.
5. Set the mixer down on a pallet, secure it against slipping and lift it out of the operating
space.
▶ Removal is complete. Clean and disinfect the mixer thoroughly.
‡
Mixer decommissioned.
‡
Protective equipment put on according to work regulations.
1. Disconnect mixer from power supply.
2. Disconnect and wind up the connection cable.
3. Insert lifting equipment in hoist.
4. Slowly lift mixer and remove it from the basin. During the lifting procedure, remove the
connection cable from the lifting equipment and wind it up.
en-US
33