Stihl GHE 105.0 Manual De Instrucciones página 35

Item Designation
O Torx screw
P5 x 20
P Torx screw
P5 x 10
Q Combination spanner
Instruction manual
7. Preparing the machine for
operation
Risk of injury:
Observe the safety instructions in
the "For your safety" section. (
7.1 Attaching wheel axle and
wheels
● Attach the wheel axle (F) to the
wheel carrier (B) with the bolts (J) and
nuts (K) using the combination
spanner (Q) (4 - 6 Nm).
● Push the washers (L) and wheels (G)
onto the mounted wheel axle.
● Attach the wheels to the wheel axle
using quick fasteners (M). Quick
fasteners must be pushed onto the
wheel axle only to the extent that the
wheels can still turn freely once
mounted.
● Press on the wheel caps (H).
Quick fasteners (M) can only be
detached by destroying.
7.2 Installing the ejection chute
extension and chassis
● Place basic unit (A) with the
chute facing downwards onto a
level, clean surface.
0478 201 9915 C - EN
● Engage the hooks (1) of the ejection
Qty.
chute extension (C) into the
3
openings (A) on the rear of the basic
unit and tilt the extension so that the
2
front part of the basic unit is precisely
inserted in the opening of the ejection
1
chute extension.
1
● Install the screws (P) in the hooks (1)
as shown (1 - 2 Nm).
● Push the chassis with both wheel
carriers (2) up to the stop in the guides
on the basic unit (A).
● Push the wheel carrier (3) into the
recess on the ejection chute extension.
4.)
● Fasten the chassis with bolts (N)
(1 - 2 Nm).
3
7.3 Installing the discharge flap
● Insert strip (E) into ejection chute
extension. Install screws (O)
(1 - 2 Nm).
● Lift garden shredder into upright
position.
● Position discharge flap (D) on ejection
chute extension. Ensure that the ribs (1)
inside the flaps on the left and right are
correctly located in the guide groove of
the ejection chute extension (2) when
attaching.
● Press in pins (I) on left and right.
7.4 Opening and closing the
discharge flap
Opening the discharge flap:
4
● For shredding, fold the discharge
5
flap (D) upwards and allow the tab (1)
to engage in the ejection chute
extension.
Closing the discharge flap:
● For transport or space-saving storage,
lift the tab (1) slightly and fold away the
discharge flap (D) downwards.
7.5 Tool box
● The combination spanner (Q)
can be inserted from below into
the tool box (2) in the rear section of the
chute (1).
8. Notes on working with the
machine
8.1 What material can be processed?
Organic plant trimmings such as fruit and
vegetable cuttings, flower cuttings, leaves,
6
tree and hedge cuttings, as well as thick
branches with side shoots and twigs.
Tree and hedge cuttings should be
processed when fresh, as the
shredding performance is better
with fresh than with dried-out or wet
material.
8.2 What material cannot be
processed?
Stones, glass, bits of metal (wire, nails,
etc.) or plastic must not be fed into the
garden shredder.
As a general rule:
7
Any materials that do not belong on the
compost heap should not be processed
using the garden shredder.
8
33