Troubleshooting - Teac NS-X1 El Manual Del Propietario

If you experience any problems with this unit, please take the time to read through these pages and see if you can solve the problem yourself
before you call your dealer or a TEAC service center.
Moreover, the problem might be caused by something other than this unit. Confirm that connected devices are also being used properly.
Erratic behavior of the unit during video/audio playback
Make sure that the file being played uses one of the formats shown on page 31 "Specifications".
o
Install the latest operating system version on the iPod/iPhone.
o
If the problem continues to occur, put the unit into standby and then on by pressing the STANDBY/ON (
o
Then, make sure that the above two conditions are met.
No sound output via dock connection during video playback
Play video via AirPlay.
o
Symptom
No power
No sound
Remote control does
not operate
St atio ns c ann ot b e
received
Preset stations cannot
be received
Poor FM reception
C ann ot co nn e c t to
network
Internet radio broadcast
cannot be played

Troubleshooting (1)

Possible cause
The AC input cord is disconnected.
Poor connection at AC wall outlet or the outlet
is dead or off.
The master volume is adjusted too low.
The MUTE button is pressed to "ON".
Incorrect selection of input source.
Incorrect connections between the components.
No battery is inserted or the battery is exhausted.
The remote sensor is obstructed.
No antenna is connected.
The desired station frequency is not tuned in.
Antenna is in wrong position.
An incorrect station frequency has been
memorized.
The memorized stations are cleared.
No antenna is connected.
The antenna is not positioned for the best
reception.
No LAN/ETHERNET cable is connected.
No available wireless connection.
Network down.
Insufficient signal strength (wireless connection).
Network is disconnected.
Program is broadcasting in non-compatible
format.
Internet radio station is not currently broadcasting.
Remedy
Connect the cord securely.
Check the outlet using a lamp or another
appliance.
Adjust the master volume.
Press the MUTE button to cancel the muting
effect.
Select the desired input source correctly.
Make connections correctly.
Insert or replace the battery.
Remove the obstacle.
Connect an antenna.
Tune in the desired station frequency.
Move antenna and retry tuning.
Memorize the correct station frequency.
Memorize the stations again.
Connect an antenna.
Change the position of the antenna.
Connect a LAN/ETHERNET cable.
Check for available wireless connection.
Check that network is working.
Shorten the distance from the wireless
LAN's access point or remove any obstacles.
Check the connection status.
Only Internet radio programs in MP3, WMA,
WAV and AAC formats can be played in this
receiver.
Tune in a radio station that is currently
broadcasting.
Continued on the next page
¤) button.
29