Hitachi Koki CH 10DL Instrucciones De Seguridad Y Manual De Instrucciones página 22

English
Symptom
Does not operate.
Tool
The tool does not trim
well.
22
Possible cause
The Lock Off button was not
pressed when the switch was
pulled back.
The blade has become dull.
[Shrub shear]
The blade stopped because it was
used to cut a branch whose width
exceeded the blade's cutting
capacity.
NOTE:
Work that will repeatedly
cause the blade to stop will
eventually damage the
motor.
Remedy
To prevent accidents from
incorrect operation, the Lock Off
switch must be pressed while the
switch is pulled back to start the
motor.
Use a wire brush or other tool to
remove sap and rust and use a file
or whetstone to sharpen the
blade. If these efforts fail to make
the blade sharper, the blade has
reached the end of its service life.
Replace the blade with a new one.
Some garden trees have wood
that is very hard and may be
beyond the capacity of the tool
even if it is of a width that is
within normal capacity. Use a
pair of pruning shear to remove
thick branches before starting
work.
An oblique cut may also exceed
the capacity of the tool since the
length of the cut increases. Be
sure to trim thick branches at right
angles.