Publicidad
2.
Assemble the Vanity
Studs/Montants/Varillas roscadas
Front Rail (with tube)
Rail avant (avec tube)
Riel delantero (con tubo)
Rear Rail
Rail arrière
Riel posterior
Left Frame
Cadre gauche
Marco izquierdo
NOTE: Slight pressure might be needed to assemble the components.
Assemble the Right Frame
Lay the right frame on a protective surface with the red interior facing up.
Place seven studs into the stud inserts, as shown.
Insert four wood dowels into the dowel holes.
Position the bottom assembly over the right frame, aligning the holes over the
studs and dowels. Then insert the assembly onto the frame.
Align and insert the front rail (with tube) onto the corner connector, studs, and
dowel on the frame.
Align and insert the rear rail onto the studs and dowel on the frame.
Position the lower rails with the tabs facing the center of the vanity and the holes
facing the bottom of the vanity. Align and insert the rails onto the lower corner
connectors on the frame. Secure with two #6 x 1/2" screws provided.
Attach the Left Frame
Place seven studs into the stud inserts on the left frame.
Insert four wood dowels into the dowel holes on the left frame.
Align and insert the studs, wood dowels, and corner connectors on the left frame
onto the bottom assembly and rails.
Kohler Co.
Right Frame
Cadre droit
Marco derecho
Bottom Assembly
Ensemble inférieur
Montaje inferior
Lower Rail
Rail inférieur
Riel inferior
7
Wood Dowels
Goujons en bois
Espigas de madera
Connector
Connecteur
Conector
1106935-2-B
Publicidad
