Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Surface burner
Problem
All burners do not
light.
Surface burners do
not light.
A surface burner
clicks during
operation.
The burners do
not burn evenly.
Very large or
yellow surface
burner flames.
44
English
FULL_RANGE TOP_DTT48T960GS_DG68-01474A-01_EN+MES+CFR.indb 44
FULL_RANGE TOP_DTT48T960GS_DG68-01474A-01_EN+MES+CFR.indb 44
Possible causes
The rangetop is unplugged.
A fuse may have blown; the
circuit breaker may have
tripped.
The gas supply is not
properly connected or
turned on.
The control knob is not set
properly.
• The burner caps are not
in place.
• The burner base is
misaligned.
The control knob has been
left in the Lite position.
Burner components are not
assembled correctly.
Burners are dirty.
The wrong burner orifice is
installed.
Action
Make sure the power cord is plugged
into a live, grounded outlet.
Replace the fuse or reset the circuit
breaker.
See your rangetop's Installation
Instructions.
Push in the control knob and turn it to
the Lite position.
• Clean the electrodes.
• Put the burner cap on the burner
head.
• Align the burner base.
After the burner ignites, turn the
control knob to the desired setting;
if the burner still clicks, contact a
service technician.
Review pages 40-42.
• Clean the burner components.
• Review pages 37, 38, 40.
Check the burner orifice size, and
contact your installer if you have
the wrong orifice (LP gas instead of
natural gas or vice versa).
2023-04-25 오후 6:03:41
2023-04-25 오후 6:03:41
Publicidad
