Installation Requirements - Hofmann monty 1520-2 Manual De Operador

monty 1520-2
USA - CANADA
i. Installation requirements
THE INSTALLATION SHALL BE CARRIED OUT ONLY
BY QUALIFIED PERSONNEL AND WITHIN THE
SCOPE OF THE INSTRUCTIONS PROVIDED IN THIS
MANUAL.
Install the machine in a covered and dry area.
Operation temperature is +41/+122 °F (+5/50 °C).
The installation requires a free space (A x B Fig.i-1) of
at least:
87" x 87" (2200 x 2200 mm)
or
138" x 87" (3500 x 2200 mm), if the tyre changer is
fitted with the bead pusher easymont pro (MH310).
i-1
Make sure that from the operating position the user
can see all of the machine and the surrounding area.
The operator shall forbid, in such an area, the presence
of non authorized persons and of objects which may
create possible hazards.
The machine shall be installed on a horizontal floor
preferably even. Do not install the machine on a sinking
or irregular floor.
If the machine is installed on a raised floor, the floor
must have a capacity of at least 110lbsxsqft (5000 N/
m² o 500 kg/m²). The machine must be secured to
the floor through the holes provided in the cabinet.
Expansion screws 12x120mm shall be used.
Drill 12mm holes in the floor flush with the holes provided
in the cabinet.
Place the nogs into the holes drilled in the floor and
move the machine so that the holes of the cabinet are
flush with the holes in the floor. Tighten the screws at
51 ft lb (70 Nm).
x
58 Operator's Manual