Tabla de contenido
Publicidad
monty 3550
2.0 Installation
Install the machine in a covered and dry place. Operation
temperature is +41/+122 °F (+5/50° C). The machine can
work below 32 °F (0° C), but some minor modifi cations
are required: contact your Hofmann distributor for detailed
information.
A. Remove the screws that attach the machine to
the pallet.
B. Lift the machine with an appropriate lifting tool (crane,
fork lift) and a belt of suffi cient capacity (3500 N).
For this operation, it is required to be helped by a second
person. Always mind the center of gravity of the machine
(Fig 2.0-1).
BE CAREFUL NOT TO DAMAGE THE AIR HOSES.
C. Remove the safety means from the mounting arm.
D. When fi rst setting the machine into operation, check
hose connections and unions for leakage.
E. The machine must be secured to the fl oor through
the holes provided in the cabinet.
Moving-IMAGE.png
Expansion screws 12x120mm shall be used.
2.0-1
Drill 12mm holes in the fl oor fl ush with the holes provided
in the cabinet.
Place the nogs into the holes drilled in the fl oor and move
the machine so that the holes of the cabinet are fl ush
with the holes in the fl oor. Tighten the screws at 70 Nm
(51 ftxlb).
2.1 Electrical Installation
WARNING
ALL ELECTRICAL CONNECTIONS SHALL BE
PERFORMED BY A LICENCED TECHNICIAN. ALL
SERVICE MUST BE PERFORMED BY AN AUTHORIZED
SERVICE TECHNICIAN.
540.tif
FOR ELECTRIC MOTOR TYPE ONLY:
Check that the electrical specifi cations of the power source
are the same of the machine. The machine uses 0.75 kW.
Electric specifi cations are clearly marked on a label at the
end of the electric cord.
If the plug is provided disregard this paragraph.
Connect the electric cord of the machine with an approved
plug. The ground cable (green and yellow) must be
properly connected.
WARNING!
FAILURE TO PROVIDE PROPER ELECTRICAL
SUPPLY AND GROUNDING WILL CREATE A SHOCK
HAZARD TO THE OPERATOR.
20
Publicidad
Tabla de contenido
