9 Diagnostics and servicing
Failure
Code
Reason
Text mes-
sage
•
F013
Sensor does not detect an
echo during operation
no measured
•
Process component or probe
value avail-
contaminated or defective
able
•
F017
cation
Adjustment
span too small
•
F025
Index markers are not con-
tinuously rising, for example
Error in the
illogical value pairs
table
•
F036
Failed or interrupted software
update
No operable
software
•
F040
Hardware defect
Error in the
electronics
•
F041
Probe mechanically defec-
tive
Probe loss
•
F080
General software error
General soft-
ware error
•
F105
The instrument is still in the
start phase, the measured
Measured
value could not yet be
value is deter-
determined
mined
•
F113
EMC interference
•
Transmission error during
Communica-
external communication with
tion error
4-wire power supply unit
•
F260
Error in the calibration car-
ried out in the factory
Error in the
•
Error in the EEPROM
calibration
•
F261
Error during setup
•
Error when carrying out a
Error in the
reset
instrument
•
False signal suppression
settings
faulty
54
This status message is inactive by default. It can be activated by the
user via PACTware/DTM or EDD.
The following table shows the error codes in the status message
"Failure
in mind that some information is only valid for four-wire instruments.
Recti cation
•
Check for correct mounting
and/or parameter settings
•
Clean or exchange process
component or probe
•
-
Change adjustment accord-
ence between min. and max.
•
Check values of the lineari-
•
Delete/create a new lineari-
•
Repeat software update
•
Check electronics version
•
Exchanging the electronics
•
Send instrument for repair
•
Exchanging the electronics
•
Send instrument for repair
•
Check probe and exchange,
if necessary
•
Disconnect operating voltage Bit 5 of Byte 0 ... 5
•
Wait for the end of the
switch-on phase
•
Duration depending on
the version and parameter
adjustment max. 5 min.
•
•
Exchange 4-wire power sup-
ply unit or electronics
•
Exchanging the electronics
•
Send instrument for repair
•
Carry out a reset
•
Repeat setup
DevSpec State in CMD 48
Bit 0 of Byte 0 ... 5
Bit 1 of Byte 0 ... 5
-
Bit 2 of Byte 0 ... 5
Bit 3 of Byte 0 ... 5
Bit 4 of Byte 0 ... 5
Bit 13 of Byte 0 ... 5
Bit 6 of Byte 0 ... 5
Bit 12 of Byte 0 ... 5
Bit 8 of Byte 0 ... 5
Bit 9 of Byte 0 ... 5