Balluff BMD 1L Serie Manual De Instrucciones página 154

11 Supplement
Cable: ø 2 mm (0.079 in)
Cable: ø 4 mm (0.157 in)
Rod: ø 8 mm (0.315 in)
Rod: ø 12 mm (0.472 in)
Torque for NPT cable glands and Conduit tubes
Stainless steel housing
Input variable
Measured variable
Min. dielectric constant of the medium
Cable probes
Rod probes
Output variable
Output signal
Range of the output signal
Signal resolution
Fault signal, current output (adjustable)
Max. output current
Starting current
Load
Damping (63 % of the input variable),
adjustable
HART output values according to HART 7 (default setting)
First HART value (PV)
Second HART value (SV)
Third HART value (TV)
Fourth HART value (QV)
Indication value - Display and adjustment module
Displayed value 1
Displayed value 2
Resolution, digital
Output variable - Additional current output
For details on the operating voltage see chapter "Voltage supply"
Output signal
Range of the output signal
Signal resolution
The output values can be assigned individually.
1)
The indication values can be assigned individually.
2)
66
6 Nm (4.43 lbf ft)
6 Nm (4.43 lbf ft)
6 Nm (4.43 lbf ft)
10 Nm (7.38 lbf ft)
max. 50 Nm (36.88 lbf ft)
Level of liquids
r
r
4 ... 20 mA/HART
3.8 ... 20.5 mA/HART (default setting)
7
0.3 μA
21.5 mA
see load under Power supply
0 ... 999 s
1)
Linearised percentage value, level
Distance to the level
Measurement certainty, level
Electronics temperature
2)
Filling height Level
Electronics temperature
< 1 mm (0.039 in)
4 ... 20 mA (passive)
3.8 ... 20.5 mA (default setting)
0.3 μA