Publicidad
Idiomas disponibles
Idiomas disponibles
3.4.
Cleaning and maintenance
a)
Service interval table:
Operation
Checking the
engine
level
General
condition
the machine
Drive belts
Tire pressure
Cleaning the
exterior of the
engine
and
the radiator
Change
engine oil
Replacing the
air filter
Replacing the
spark plug
b)
Before each cleaning, adjustment or replacement of accessories, and when the
unit is not in use, turn off the machine and cool it down completely, also
remove the ignition cable pipe from the spark plug.
•
Wait until the rotating parts stop.
c)
Use only non-corrosive cleaning agents for cleaning the surfaces.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
j)
Check the fuel cables regularly for any damage or wear (cracks or leaks) and
replace the damaged component immediately.
k)
Spark plug inspection/replacement:
Before
After every 3
each
hours of
use
operation
oil
X
of
X
X
Every 25
Every 100
hours of
hours of
operation
operation
X
X
X
X
X
Publicidad
