Publicidad
Idiomas disponibles
Idiomas disponibles
Turn off electrical power before handling, cleaning, or replacing an electrode.
•
Ensure that the grounding cable is properly connected and that the plug is properly connected
•
to a grounded outlet. Improper grounding of the unit may result in a risk to life or health.
Regularly inspect current cables for damage or lack of insulation. A damaged cable should be
•
replaced. Careless repair of insulation may result in death or personal injury.
Turn off the unit when not in use.
•
•
Do not wrap the cable around your body.
•
The welded object must be properly grounded.
Only use equipment that is in good condition.
•
•
Repair or replace damaged equipment. Use safety belts when working at heights.
Keep all equipment and safety items in one place.
•
Keep the tip of the handle away from the body when the trigger is activated.
•
•
Attach the ground cable to the workpiece or as close to it as possible (e.g. to the workbench).
Caution! The machine may still be live when the power cord is disconnected.
After turning off the unit and disconnecting the voltage cable, check the voltage on the input
•
capacitor and make sure that the voltage value is zero, otherwise do not touch the unit
components.
4.6. Gases and fumes
Caution! Gas can be hazardous to health or lead to death!
•
Always keep a distance from the gas outlet.
When welding, pay attention to proper ventilation of the room to avoid inhalation of vapors
•
and gases.
•
Chemical substances (lubricants, solvents) must be removed from the surface of the
workpieces to be welded as they burn under the influence of heat and release poisonous
fumes.
Welding of galvanized workpieces is only allowed with efficient extraction and filtration and a
•
clean air supply. Zinc vapors are very toxic, and the symptom of poisoning is the so-called zinc
fever.
5. Instructions for use
5.1. General
Use the equipment for its intended purpose, observing the safety regulations and restrictions
•
resulting from the data on the rating plate (IP degree, duty cycle, supply voltage, etc.).
•
The unit must not be opened, as this will void the warranty. In addition, exploding naked parts
may cause personal injury.
•
The manufacturer is not responsible for technical changes to the unit or material damage
resulting from such changes.
•
In case of malfunction contact the service department.
Do not block the ventilation slots of the unit - position the welding machine at a distance of 30
•
cm from surrounding objects.
Do not hold the welding machine under your arm or close to your body.
•
The unit must not be installed in rooms with aggressive environment, high dust and near units
•
with high electromagnetic field emission.
Publicidad
