STAMOS S-WIGMA200M Manual De Instrucciones página 24

A - Display
B - Graph showing the welding parameters that can be adjusted. Switching between parameters is done
by pressing the knob, and adjusting the value by turning it.
C - "SPOT TIG" function button (TIG spot welding). Press this button to adjust the frequency and duty
cycle of the spot welding.
D - Mode selection button: 2T / 4T / SPOT.
• 2T: When the torch button is pressed, welding starts, and the button must be pressed to
continue. When the button is released, welding stops.
• 4T: When the torch is pressed and released, welding starts. When pressed again and released,
welding will stop. The 4T mode is recommended for longer welding.
• SPOT: TIG spot welding
E - Control knob and function switching button to be adjusted. Pressing and holding this button for 5
seconds restores the factory settings.
F - Pulse TIG / TIG / MMA mode switching button. Pressing and holding this button for 3 seconds will save
the data. After turning on the device, it will display the data saved by the user.
G - REM: Remote control mode indicator light.
H - ⚡: Emergency mode indicator light.
Adjustable parameters: