Publicidad
Idiomas disponibles
Idiomas disponibles
1) Connect the ground cable to the connection marked with "+" and twist the cable plug to
secure the connection.
2) Connect the welding cable to the connection marked with "-" and twist the cable plug to
secure the connection.
3) Connect the torch gas cable to the gas outlet connection on the front panel of the welder.
4) Connect the shielding gas cylinder with a pressure reducer to the gas inlet on the rear panel
of the machine using a gas hose.
5) Connect the TIG torch control cable to the connector on the front panel of the machine.
6) Plug the power cord into an electrical outlet and start the machine.
7) Connect the ground wire to the workpiece. Once these steps are completed, welding can
begin.
MMA welding mode:
1) Connect the welding cable to the connection marked with "+" and twist the cable plug to
secure the connection.
2) Connect the ground wire to the connection marked with "-" and twist the wire connector to
secure the connection.
3) Connect the power cord and turn on the power.
4) Connect the ground wire to the workpiece. Once these steps are completed, welding can
begin.
CAUTION! Cable polarity may vary! All polarity information should be described on the
package provided by the electrode manufacturer!
8. Disposal of the packaging
Please keep all packaging material (cardboard, plastic strips and polystyrene foam) to ensure that the
unit is protected during shipment, should it become necessary to send it to a service center!
9. Transport and storage
When transporting the unit, protect it from shocks and tipping over, and do not place it "upside
down". Store the unit in a well-ventilated room where dry air is present and corrosive gases are not
present.
10.
Cleaning and maintenance
Pull the mains plug before each cleaning and when the unit is not in use and cool the unit
completely.
Use only non-corrosive cleaning agents for cleaning the surfaces.
Do not spray the unit with a stream of water or immerse it in water.
Make sure that no water enters through the ventilation openings in the casing.
Clean the ventilation openings with a brush and compressed air.
After each cleaning, all the parts should be dried well before the unit is used again.
Store the unit in a dry and cool place protected from moisture
and direct sunlight.
- Remove dust regularly with dry and clean compressed air.
- Protect the unit from water and moisture.
- The welding machine must not be placed on a heated surface.
- Store the machine in a dry and clean room.
Publicidad
