STAMOS S-WIGMA200M Manual De Instrucciones página 25

1 - "PreFlow" (gas pre-flow) - gas flow time before starting welding.
2 - "Start Current" - the value of the output current after the arc is struck.
3 - "UpSlope" - the time during which the value of the output current increases from the value of the
initial current to the value of the welding current.
4 - "Peak Current" - the value of the welding current (in TIG and MMA mode) or the peak current in
TIG PULSE mode.
5 - "Duty" (pulse width/duration) - this is the ratio of the duration of the pulse to the period of this
pulse. Parameter set in TIG PULSE mode.
6 - "Pulse Frequncy" - pulse frequency during TIG PULSE welding.
7 - "Base Current" - the current that maintains the arc in TIG PULSE mode.
8 - "DownSlope" - the time during which the output current value drops from the welding current
value to the final current value.
9 - "Crater Current" - the value of the output current before the end of welding.
10 - "PostFlow" (gas postflow) - gas flow time after the end of welding. Function used to cool the
weld and protect it from oxidation.
11 - "Hot Start" (in MMA mode) function that facilitates the start of welding. At the moment of arc
ignition the welding current is briefly increased. This heats up the material and the electrode in the
area of contact as well as the appropriate shape of the fusion and the weld face (in the initial phase
of the welding process).
12 - "Arc force" (in MMA mode) a function that provides the best settings for a stable arc and low
spatter.
TIG torch: