SIS SIS10.ESY.00 Manual Del Usuario página 32

Except in the event of wilful misconduct or gross negligence, the Manufacturer cannot be held liable towards the Buyer, even if the
latter is a Distributor of the product, for any damage or loss suffered by it following or as the result of any warranty action by an end
user of the product or recourse by a different intermediary in the distribution change or any other intermediary, with express waiver by
the Buyer of any action or recourse.
1.5.3 Warranty for epidemic defects
The Supplier warrants that the products are free from epidemic defects.
A supply is considered as having an epidemic defect when the defect or fault, even if minor, is repeated more than twice in the same
lot, or when it is repeated only once in three consecutive lots.
If a supply of products is ascertained to have an epidemic defect, the Supplier undertakes to replace the entire supply and bear all the
related expenses.
1.5.4 Guarantee of marketability and suitability for the intended use
Due to the exclusive nature of the product supplied, standard performance is ruled and the Manufacturer is not required to guarantee
results other than those specified in the instruction handbook and the other illustrative material.
Likewise, the guarantee of suitability for the intended use only applies if there is an express agreement between the parties to this end.
In this case, the Buyer must provide the Manufacturer with all the data required to assess the intended use of the product, and if the
Manufacturer agrees to issue the warranty, follow carefully the technical and operating instructions provided for installation and comply
with the specifications and limits of utilisation indicated.
1.12. Applicable standards and compliance with the law
The SIS Easy anti-collision device has been manufactured and the attached documents drawn up in accordance with the following
standards:
•
Directive 2006/42/CE: Machinery Directive
•
Directive 2004/108/CE: Electromagnetic Compatibility
•
UNI EN ISO 12100: Safety of machinery – General principles for design – Risk assessment and risk reduction
•
CEI EN 60204 – 1: Safety of machinery – Electrical equipment of machines - Part 1: General Rules
1.6.1 Legislative Decree no. 81 of 9
In addition to the rules set out in the User Manual, the User of the machine must comply with the applicable laws on occupational
health and safety, in accordance with Legislative Decree no. 81 of 9
Art. 20: Workers' obligations
3. Workers must look after their own health and safety and that of the other people present in the workplace, who could be effected
by their actions or omissions, in accordance with the training, instructions and equipment provided by the employer.
4. In particular, workers must:
a. contribute, together with the employer, executives and supervisors, to fulfilment of the obligations provided for the
protection of health and safety in the workplace;
b. observe the provisions and instructions imparted by the employer, executives and supervisors for the purpose of collective
and invidual protection;
c. make proper use of the work equipment, hazardous substances and preparations, means of transport and safety devices;
d. make appropriate use of the personal protection equipment provided;
e. report immediately to the employer or an executive or supervisor any lack of the equipment and devices as per letters c)
and d), and any hazardous situation that comes to their knowledge and, in urgent cases, intervene directly in as far as their
skills and capability allow, subject to the obligations under letter f), in order to eliminate or reduce situations of grave and
imminent danger, and inform the worker safety representative thereof;
f. not remove or modify any of the safety, warning or control devices, unless authorised to do so;
g. not perform on their own initiative any operations or manoeuvres that do not fall within their competence or may jeopardize
their own safety or that of other workers;
h. attend the training courses organised by the employer;
i. undergo the medical check-ups provided for in this legislative decree or ordered by the factory doctor.
th
April 2008 as amended
th
Pagina 32
April 2008 as amended:
MNL.000001 Rev.03 25.09.2019