SIS SIS10.ESY.00 Manual Del Usuario página 45

Sensor must be parallel to the ground and with the connector side up.
4.5.2 Hole layout
1
Figure 25: CySens sensor hole layout
Once the sensor is fixed on the vehicle connect the sensor cable.
Figure 24: Example of CySens sensor positioning
1
1
Vehicle rear limit
The sensor is mounted using the two M8 projecting
bolts on the back (Figure 15).
The safety bracket and 90° leg provided come with
holes for this purpose.
An alternative is to make your own brackets. Figure 19
1
shows the centre distances and measurements
required.
When tightening the nuts on the projecting bolts (ref.
1, Figure 19), insert a socket wrench in the end to
prevent rotation.
Pagina 45
MNL.000001 Rev.03 25.09.2019