SIS SIS10.ESY.00 Manual Del Usuario página 44

4.4.2 Advanced display inputs/outputs
Signal
+10-36V supply
GND supply
Sensor power supply (+)
Sensor power supply (-)
Sensor A2
Sensor A1
Sensor OK
RS485 A
RS485 B
RS485 GND
Reverse signal
4.4.3 Power supply connection
•
Find on the veichle an after contact voltage between 10VDC and 36VDC(*)
•
Connect MiniMind power supply to the above mentioned source ( RED wire + / Black wire - )
(*) : if only an higher voltage is available a DC/DC converter may be required.
4.4.4 Reverse signal connection
•
Find on the veichle a positive voltage between 10VDC and 36VDC which is active with reverse gear only (**)
•
Connect MiniMind reverse signal to the above mentioned source ( Turquoise wire )
(**) : if only an higher voltage is available an additional realy or a switch may be required.
4.4.5 CySens sensor connection
•
Connect the sensor cable to the display cable as shown in the shematic of this manual
1.30. How to install the CySens sensor
Figure 23: CySens sensor
Figure 14 shows the optimal installation dimensions. The sensor must be mounted about 110 cm above ground level, centrally with
respect to the vehicle width. This is to prevent the ground from being detected by the sensor.
The front edge of the sensor must be within the rear limit of the vehicle to reduce the risk of impact.
Description
10-36V general power input
10-36V general ground supply
S1 sensor 10-36V power output
S1 sensor 10-36V GND output
A2 signal input – sensor S1
A1 signal input – sensor S1
OK signal input – sensor S1
Bus RS485 I/O "A"
Bus RS485 I/O "B"
Bus RS485 I/O "GND"
Activation signal input (reverse)
4.5.1
Points to bear in mind when installing the sensor (Figure 13)onboard the
vehicle.
•
•
•
•
Onboard installation
The display must be located in the most impact-free position possible.
Do not apply pressure to the TX transmission / RX reception capsules
as deformation could affect operation.
The sensor must be positioned so that there are no fixed elements of
the vehicle (e.g. uprights) in the range of action.
The cable must be laid and secured in such a way as to protect it from
damage by impact or wrenching.
Pagina 44
MNL.000001
Colour (code) Colour
RD Red
BK Black
BN Brown
BU Blue
WH White
YE Yellow
GN Green
OG Orange
VT Violet
GY Grey
TQ Turquoise
Rev.03 25.09.2019