Descargar Imprimir esta página

SIS SIS10.ESY.00 Manual Del Usuario página 36

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

MNL.000001
Rev.03 25.09.2019
1.23.
Prohibited uses
Use of the device for purposes other than that for which it was designed and built is considered an abnormal condition and
may damage the vehicle and put the User in serious danger.
The SIS Easy anti-collision device must not be installed on any type of vehicle other than small forklift trucks up to a
maximum width of 200 cm.
The SIS Easy anti-collision device is particularly indicated for electric forklift trucks .
With vehicles using other systems (e.g. diesel or gas), it operates correctly with regard to the electricity supply but the
presence of warm air in the detection area coming from the heater can require a different positioning of the sensor.
The SIS Easy anti-collision device cannot be used to detect obstacles at distances higher than that for which it was
designed and built (see Figura 4).
The SIS Easy anti-collision device must not be used in wet, dusty or muddy areas because the ultrasonic detection system
cannot operate in such environments.
Do not use the SIS Easy anti-collision device in noisy environments where other ultrasonic machines are operating, or in
the presence of structural conditions likely to alter the normal detection function, as this could interfere with the signal
to/from the sensor and generate a false alert.
Improper use of the device and a lack of maintenance or cleaning could cause a hazard for the operator and other
personnel or damage the vehicle and work materials or environments, in addition to affecting the operation and safety of
the device itself.
The position and dimensions of the device must never be modified in view of altering its operation.
If you wish to change any of the parameters or do something not covered by this User Manual, please contact the dealer
from which you purchased it.
Do not use pressurized water to wash or clean the vehicle on which the SIS Easy anti-collision device is installed as this
could damage the working parts. Use a specific detergent to clean the vehicle.
Installation and set-up of the SIS Easy anti-collision device must be performed as instructed in this User Manual. Any other
type of operation and maintenance is prohibited.
Unauthorised or unqualified personnel or minors must never be allowed to operated the vehicle, even if it is fitted with an
SIS Easy anti-collision device.
Do not use the vehicle in poor lighting or visibility, even if it is fitted with an SIS Easy anti-collision device.
Maintenance and repairs must not be carried out by unauthorised or untrained personnel.
Pagina 36

Publicidad

loading