SIS SIS10.ESY.00 Manual Del Usuario página 40

MNL.000001 Rev.03 25.09.2019
How to install the SIS Easy anti-collision device
1.26. Important recommendations
The Buyer/User is responsible for installing and setting up the SIS Easy anti-collision device. These operations must be
performed by fully qualified personnel whom the Buyer/User has ascertained to be in possession of the technical and
professional requirements.
Prior to installation, the Buyer/User, or the Fitter, must consult:
• the data on the SIS Easy anti-collision device rating plate;
• the general wiring diagram (Figura 10);
• the instruction handbook for the industrial vehicle on which the system is to be installed, more specifically the wiring
diagram, in order to identify the best branching point.
It is also advisable to consult the vehicle manufacturer first to verify compatibility with the SIS Easy anti-collision device. If
you have any problems with the system, contact your local dealer.
The system must be installed in accordance with the instructions in this User Manual.
Prior to installation, make sure the vehicle is compatible with the SIS Easy anti-collision device in terms of mass, weight
and technical features.
N.B. The SIS Easy anti-collision device should not be installed on any type of vehicle other than small forklift trucks up to a
maximum width of 200 cm.
The system must be installed in accordance with the rules of good practice in order not to compromise the vehicle's
operational safety.
The Manufacturer disclaims all liability for damage or injury caused if the vehicle is tampered with in any way.
The SIS Easy anti-collision device must be installed without making any modifications to it.
The Manufacturer disclaims all liability for damage or injury caused if the system is tampered with in any way.
It is advisable to connect device power supply after contact, so it can switch on and off at the same time as the vehicle on
which it is fitted.
The SIS Easy anti-collision device is particularly indicated for electric forklift trucks.
With vehicles using other systems (e.g. diesel or gas), it operates correctly with regard to the electricity supply but the
presence of warm air in the tection area coming from the heater can require a different positioning of the sensor.
The SIS Easy anti-collision device must not be used in wet, dusty or muddy areas because the ultrasonic detection system
cannot operate in such environments.
Do not use the SIS Easy anti-collision device in noisy environments where other ultrasonic machines are operating, or in
the presence of structural conditions likely to alter the normal detection function, as this could interfere with the signal
to/from the sensor and generate a false alert.
Pagina 40