Installing Instructions - Telstar Bio II Advance Plus Serie Manual De Usuario

3. INSTALLING INSTRUCTIONS

For a correct start-up procedure of the microbiological safety cabinet, observe the following
step-by-step instructions.
3.1. TRANSPORT
The cabinet is supplied in an individual package and in the suitable way to prevent it from
being damaged.
This manual and certificate of individual Quality controls of each cabinet are
included in the scope of supply.
3.2. PLACING ON SITE
a) Special care should be taken when unpacking the front glass and the control display.
b) Use the same packaging base for the transport to its final location and it is highly
recommended doing it with a pallet jack. The cabinet has two M10 eyebolts to help to
position it on a raised surface. If there are no mechanical means to position it, this can
be done manually.
WARNING
We advise against the use of lift trucks for placing the cabinet directly by its base. In such
case, it should be handled with care and it is also a must that:
- the useful length of the forks of the lift-truck are over 750 mm.
- the cabinet is fully supported all along its width (front (A) and rear (B)
structural profiles). Direct visual inspection during its handling is required.
UM-BioIIAdvancePlus-EN-1812 8 / 35