Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL MANUAL. START-UP AND OPERATION
Press the key "set" for at least 2 seconds, then enter the state of temperature setting, here the LED displays the setting tempera-
i
ture, then using "
" key or "
hold it over 0.5 seconds can add or minus rapidly). After setting, press "set" again, then exit the state of parameter setting. (The
setting temp range is limited by the parameters F13 and F14; please refer to the senior operation). Pressing the key "M" in the set-
ting process means cancel and exit, but the setting value will not be saved.
When displaying current temperature, press "
current temperature.
Advanced Operation
Press the key "M" and hold it for 5 seconds, and if you have set the password, the LED display the "PAS" to hint you to enter the
password, you can use the key "
i
g
code, use "
" or "
" to select the parameter code. Pressing the "set" key can make it to show the value of the parameter after
select the parameter, here you use "
then press the "set" key to return to the state of showing parameter code after finishing setting. Pressing the key "M" can exit the
parameter setting state when display the parameter code, pressing the key "M" means cancel when in the process of setting para-
meter, and the parameter will not be changed.
Internal parameter code is showing below:
18
How to set the temperature?
g
" key can change the parameter (the key "
How to read the temperature of the evaporator sensor?
g
" key, Controller will display defrosting temperature. Loose "
i
g
" and "
" to enter the password, if the password is correct, the LED will display the parameter
i
g
" or "
" to set the parameter(pressing the key and not release can add or minus rapidly),
i
g
" adds 0.1°C, the key "
" minuses 0.1°C, press and
g
" key, then return to
Publicidad
