Electrical Diagram; Single Phase Diagram; Triphasic Diagram; Operation Of The Unit - Astralpool 54068-MB Manual Tecnico

ASTRALPOOLHEAT SERIES · AIR/WATER SYSTEM ASTRALPOOLHEAT SERIES · AIR/WATER SYSTEM
ASTRALPOOLHEAT SERIES · AIR/WATER SYSTEM ASTRALPOOLHEAT SERIES · AIR/WATER SYSTEM
The heat pump should always operate in conjunction with the purification pump. Be The heat pump should always operate in conjunction with the purification pump. Be The heat pump should always operate in conjunction with the purification pump. Be The heat pump should always operate in conjunction with the purification pump. Be
careful when interconnecting timers or programmers which may stop the purification careful when interconnecting timers or programmers which may stop the purification
careful when interconnecting timers or programmers which may stop the purification careful when interconnecting timers or programmers which may stop the purification
pump and leave the heat pump pump and leave the heat pump without water flow
pump and leave the heat pump pump and leave the heat pump
All local and national electricity codes concerning the protection of defects in electric
•
power lines should be respected at all times during the electrical installation.
Verify the torque of all electrical connections.
•
The electrical resistance between the ground and any electric terminal will be verified
•
to be over 1 mega ohm. Otherwise, the equipment will not start up until electrical loss
is located and repaired.
In the case of fluctuations in the power supply, a power supply stabilizing system is
•
recommended in order to protect the equipment.
See how to connect filtration pump to the heat pump: IMAGE 3 (page 182).
4.4. 4.4.

ELECTRICAL DIAGRAM

ELECTRICAL DIAGRAM
4.4. 4.4. ELECTRICAL DIAGRAM ELECTRICAL DIAGRAM
4.4.1. 4.4.1. 4.4.1.

4.4.1. SINGLE PHASE DIAGRAM

SINGLE PHASE DIAGRAM SINGLE PHASE DIAGRAM SINGLE PHASE DIAGRAM
See IMAGE 4 (page 183)
4.4.2.

4.4.2. TRIPHASIC DIAGRAM

TRIPHASIC DIAGRAM
4.4.2. 4.4.2. TRIPHASIC DIAGRAM TRIPHASIC DIAGRAM
See IMAGE 5 (page 184)

5. 5. 5. 5. OPERATION OF THE UNIT

OPERATION OF THE UNIT OPERATION OF THE UNIT OPERATION OF THE UNIT
5.1. 5.1.

OPERATION MODES

OPERATION MODES
5.1. 5.1. OPERATION MODES OPERATION MODES
FILTRATION OR COMFORT FILTRATION OR COMFORT FILTRATION OR COMFORT FILTRATION OR COMFORT
•
FILTRATION: Heat pump will heat the pool, spa or both alternatively only when the
filtration system is running and the control has been turned on to pool, spa or pool +
spa. The unit depends on the filtration system to work.
COMFORT: Heat pump will periodically check the pool or spa temperatures, overriding
time clock settings and will heat pool, spa or both alternatively, whenever temperature
is below set points. The unit has the ability to operate regardless of filtration system
status.
POOL, SPA OR BOTH (optional) POOL, SPA OR BOTH
POOL, SPA OR BOTH POOL, SPA OR BOTH
•
POOL: The unit will work only on Pool's water.
SPA: The unit will work only on Spa's water.
POOL+SPA: The unit will alternatively work on Pool or Spa, with a given timing for each
one, defined on technical menu.
EOM or ECO EOM or ECO EOM or ECO EOM or ECO
•
EOM (Efficient Operation Mode): Heat pump will continuously check energy on the
environment and water and will decide if it is worth heating water. This option can be
activated both in Filtration and Comfort modes.
ECO (Economic mode): Heat pump will add an extra set point differential thus achieving
electrical savings.
Note that these operation modes are accumulative between them: For instance, you can Note that these operation modes are accumulative between them: For instance, y Note that these operation modes are accumulative between them: For instance, y Note that these operation modes are accumulative between them: For instance, y
set up a unit to heat Spa water in comfort mode and EOM efficient operation activated. set up a unit to heat Spa water in comfort mode and EOM efficient operation activated. set up a unit to heat Spa water in comfort mode and EOM efficient operation activated. set up a unit to heat Spa water in comfort mode and EOM efficient operation activated.
What is not possible is to make a unit work on both modes of the same category: For What is not possible is to make a unit work on both modes of the same category: For What is not possible is to make a unit work on both modes of the same category: For What is not possible is to make a unit work on both modes of the same category: For
instance, you cannot set up a unit in both Comfort and Filtration modes. instance, you cannot set up a unit in both Comfort and Filtration modes. instance, you cannot set up a unit in both Comfort and Filtration modes. instance, you cannot set up a unit in both Comfort and Filtration modes.
© ASTRALPOOL 2015 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT
without water flow. . . .
without water flow without water flow
(optional)
(optional) (optional)
.
ENGLISH ENGLISH ENGLISH ENGLISH
ou can ou can ou can
Pag: 15