Publicidad
Idiomas disponibles
Idiomas disponibles
resume its normal setting automatically. If this remedy does not solve the overload
situation, the sensor will shut off the auger motor automatically and the power indicator
will flash orange slowly/fast.
◾
When the power indicator flashes orange slowly, release the auger-switch trigger
Restart the augers and slow down your pace or decrease the snow clearing cut
width when working.
◾
When the power indicator flashes orange fast, remove the battery pack(s) from
the snow blower. Check to see if there is snow or ice buildup in the auger and
deck. If necessary, use the chute
cleaning tool to clear them out
following instructions for "CLEARING
A CLOGGED CHUTE". Reinstall the
battery pack(s) and restart the snow
blower.
CLEARING A CLOGGED CHUTE
(Fig. 14)
WARNING:
contact with the rotating auger inside the
chute is the most common cause of injury
associated with snow blowers. Never use
your hand to clean out the chute.
WARNING:
of the snow blower when the unit is operating or when the battery pack(s) are installed.
Always ensure all moving parts have stopped and the battery pack(s) have been
removed before clearing any obstructions. Failure to follow these instructions can result
in serious personal injury.
To clear the chute:
1. Stop the motors and power down the snow blower!
2. Remove the battery pack(s) from the snow blower.
3. Wait 10 seconds to be sure the auger has stopped rotating.
4. Always use the chute cleaning tool which is attached to the machine as an
accessory; DO NOT USE YOUR HAND.
30
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2800/SNT2800-FC
Hands coming in
Never reach into the discharge chute or place any body part in front
14
Chute Cleaning Tool
Publicidad
