Publicidad
Idiomas disponibles
Idiomas disponibles
Required tool (not included):
◾
one 15 mm socket wrench
To replace the skid shoes (Fig. 15a)
1. Remove the battery pack(s).
2. Loosen and remove the nuts, gaskets,
the skid shoe, and bolts on the side of
the deck.
3. Replace the skid shoe with a new one.
4. Reassemble nuts, gaskets, and bolts. Securely tighten them.
NOTE:
The steel and plastic sides of the skid shoes could be reversed for different
surfaces as needed (Fig. 15b).
To adjust the height of skid shoes
(Fig. 15c)
When encountering uneven or gravel
surfaces, the height of the skid shoes
need to be adjusted to increase the ability
of the snow blower to maneuver on the
snow.
The height of the skid shoes can be
adjusted according to the actual snow conditions without removing the nuts. Just
loosen the nuts, adjust the skid-shoe position, and then retighten the nuts.
34
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2800/SNT2800-FC
15b
15c
Steel Side
Plastic Side
Publicidad
