Publicidad
Idiomas disponibles
Idiomas disponibles
CHECKING THE TIRE PRESSURE
It is important for level removing of
the snow that all tires have the correct
amount of air pressure. If the snow blower
is not tracking straight, please check the
air pressure of the wheels first.
Check and make sure both tires are
inflated to the pressure shown in Fig. 19.
Required tools (not included):
◾
tire pressure gauge;
◾
air compressor / inflator or heavy-
duty bicycle pump.
WARNING:
tire could cause the tire to burst, causing serious personal injury.
WARNING:
little pressure could allow the tire to rotate off the wheel rim. Too much pressure could
cause the tire to burst. Failure to maintain correct air pressure in the tires could cause
problems with snow blower operation and stability, causing serious personal injury.
STORING THE SNOW BLOWER
WARNING:
properly wiped up to prevent a slip and fall hazard.
Remove the battery pack(s) and store in a secure location out of the reach of children.
NOTE:
When not in use, the battery pack(s) should be stored in an enclosed area
where the temperature will not drop below -4°F (-20°C).
Before storage, wipe any moisture, dirt, or debris from and around the battery compartment.
◾
Wipe the snow blower with a clean dry cloth.
◾
Check all nuts, bolts, knobs, screws, etc., for tightness.
◾
Inspect moving parts for damage, breakage, and wear. Have repairs made on any
damaged or missing parts.
◾
Store the snow blower in a clean, dry, enclosed place out of the reach of children.
◾
Do not store near corrosive materials such as fertilizer or rock salt.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2800/SNT2800-FC
Check the tire pressure carefully while inflating. Too much air in the
Maintaining correct air pressure in the tires is very important. Too
Ensure that all melted snow that may drip from the snow blower is
19
(16 PSI) 96.5 kPa
37
Publicidad
