Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
WARNING:
the snow blower. Always protect your hands by wearing gloves when performing any
maintenance on the snow blower auger or scraper bar.
PROBLEM
Snow blower fails to
start.
38
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2800/SNT2800-FC
Always remove the battery pack(s) when servicing or transporting
CAUSE
◾
Battery pack(s) charge is
low.
◾
The auger-switch trigger
is not depressed after the
power indicator lights up
solid green.
◾
The auger is frozen by
snow or ice.
◾
The battery pack is
overheated. The LED
indicator on the battery
pack(s) flashes orange
or shines red. (see the
section "BATTERY
HIGH-TEMPERATURE
PROTECTION" in this
manual.)
◾
Unidentified fault
SOLUTION
◾
Charge the battery
pack(s).
◾
Press the auger-switch
trigger after the power
indicator lights up solid
green. If the power
indicator is off, the snow
blower will not respond
to the pressing of
auger-switch trigger.
◾
Remove the battery
pack(s) first, then use the
supplied chute cleaning
tool to clear the snow
or ice that obstructs the
auger. Restart the snow
blower.
◾
Remove the overheated
battery pack(s) from
the snow blower and
wait until the battery
pack(s) cools down to
approximately 152°F
(67°C). Reinstall the
battery pack(s) and
restart the snow blower.
◾
Contact EGO service
center for repair.
Publicidad
