Thermador Professional Serie Guia De Instalacion página 13

Description
25 ft. remote and in-line blower
extension cable
Available to connect the hood to the
inline and remote blowers for distances
up to 25 ft.
4.3 Hood transition
Discharge direction
The hood can be mounted on a wall or suspended from a
cabinet. Both vertical and horizontal discharge are
possible with either mounting method.
Vertical discharge transition
The hood is shipped ready for vertical discharge.
The transition supplied with the hood connects to standard
10" round duct. The figure shows the transition connected
for vertical discharge.
Changing to horizontal discharge transition
The transition supplied with the hood connects to
1.
standard 10" round duct. The figure shows the transition
connected for horizontal discharge.
To change to horizontal discharge, move the discharge
SKU
2.
cover to the top of the hood. Use a ⅜'' nut driver to
EXTNCB25W
remove the four (4) ⅜" hex nuts from the plate.
Attaching the hood transition
Your hood is supplied with a 10" (254 mm) round
transition. A locally supplied transition is required for other
sizes.
The supplied transition mounts to the top or rear of the
1.
hood, depending on the discharge direction. A minimum
height clearance of 8⅜" (212 mm) is needed above the
hood for transition mounting.
Depending on direction of discharge, align the mounting
2.
holes at the base of the transition over the mounting
holes of the ½" (13 mm) flange located at the top or rear
of the hood.
Fasten the transition to the hood using four (4) ¼"
3.
(6 mm) sheet metal screws included with the hood.
Note: Make sure the screws do not hinder the damper
operation.
Preparing the installation en-us
13