Thermador Professional Serie Guia De Instalacion página 21

5.10 Installing the grease trays and filters
IMPORTANT: DO NOT use the cooktop, rangetop, or
range while the hood is disassembled.
Wall hood
View may vary.
1 2
5
Hood canopy
1
LED lights
2
Touch control panel
3
Heat lamps (PHxxGWS)
4
Baffle filters
5
Grease trays
6
Grease tray trough
7
Filter spacers
8
Installing the filters and grease trays
Turn the fan and lights off.
1.
Remove all plastic from hood pieces.
2.
3 4
6 7 8
Insert the grease tray in rear tray. Push the grease tray
3.
in and down inside the grease tray trough. Grease trays
must be in place before installing the filters.
The small grease tray must be installed in the center
‒
of hood.
Install the filters. Start with an outside filter. Grab the
4.
filter by the handle, if applicable, or by the sides. Do not
place fingers inside the filter slats. Slide the filter up,
toward the front of the hood, then push down on top of
the grease tray.
To remove the filters and grease trays, ensure the filters
5.
are cool and grease has congealed. Then proceed in
reverse order of the previous instructions.
5.11 Heat lamps (PHxxGWS only)
WARNING
Heat lamps might be hot.
Disconnect from power and allow to cool before
▶
servicing.
DO NOT operate the appliance without the heat lamps
installed.
Installation en-us
21