Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
INSTALL UPPER GUN HOLDER
See Figure 4.
From the front of the unit, remove top-right bolt, washers,
and nut. Reinstall with the upper spray gun holder. From
the rear of the unit, install the push rivet as shown.
INSERT NOZZLES
See Figure 4.
Insert the colored nozzles into the corresponding holders
on the top of the pressure washer (WPX3600 shown).
Place the trigger handle and hose in their designated
storage brackets.
CONNECTING THE LANCE TO THE
SPRAY GUN
See Figure 5.
l Push the lance into the spray gun and turn clockwise to
tighten. Do not overtighten.
l Gently pull on the lance to be certain it is secured.
CONNECTING THE HIGH PRESSURE HOSE
TO THE SPRAY GUN
See Figure 6.
l Pull the collar on the high pressure hose back and push
the hose fitting firmly onto the spray gun.
l Screw the collar onto the spray gun and tighten securely.
NOTE: Be careful not to damage the threads on the
spray gun doing so could cause the gun to leak during
use.
l Gently pull on the hose to be certain it is secured.
CONNECTING THE HIGH PRESSURE HOSE
TO THE PRESSURE WASHER
See Figure 7.
l Uncoil and straighten the high pressure hose to remove
any bends or kinks.
l Pull the collar on the high pressure hose back and push
the hose fitting firmly into the threaded outlet on the
pressure washer.
l Screw the collar onto the outlet and tighten securely.
10 | English
FIG. 4
A
C
A - Nozzle holders
B - Trigger handle
C - Hose
FIG. 5
B
A - Spray Gun
B - Lance
FIG. 6
A
A - Spray Gun
B - High Pressure Hose
C - Collar
FIG. 7
A - High pressure hose
B - High pressure outlet
B
A
C
B
B
A
Publicidad
