Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
NOTICE
Clean the fuel screen filter of debris
before and after each fueling. Remove the fuel screen
filter by slightly compressing it while removing it from
the fuel tank.
PRESSURE WASHER LOCATION
DANGER
erate the pressure washer in an enclosed area. En-
gine exhaust contains carbon monoxide that can kill
in minutes. Only operate the pressure washer outside
and away from windows, doors and vents. Place the
pressure washer in a well-ventilated area. DO NOT
place the pressure washer near vents or intakes
where exhaust fumes could be drawn into occupied
or confined spaces. Carefully consider wind and air
currents when positioning the pressure washer.
This pressure washer must have at least 5ft. (1.5m) of
clearance from combustible material. Leave at least 3 ft.
(0.91 m) of clearance on all sides of the pressure washer
to allow for adequate cooling, maintenance, and servicing.
BEFORE STARTING THE ENGINE
Verify that:
l The pressure washer is placed in an appropriate location.
l The unit is on a dry, flat, and level surface.
l The engine is filled with oil.
STARTING THE ENGINE
See Figures 12 - 14.
WARNING
safety glasses with side shields, and as necessary a
full face shield as well as full ear protection when op-
erating this product.
NOTICE
Running the unit for more than one
minute without spraying water causes heat to build up
in the pump. In the event that the pump gets too hot, a
thermal relief valve will open to release the hot water.
Running the unit without spraying water can damage
pump components and will void the warranty.
l Turn the water supply ON.
l Pull the trigger on the spray gun to purge all air from the
pump and hose. This may take several minutes.
l Do not start the engine until a steady stream of water is
flowing from the nozzle.
l Turn the engine switch to the ON position.
l Turn the fuel valve to the ON position.
l If the engine is cold, move the choke lever to the CHOKE
position.
Asphyxiation hazard. Never op-
Always wear safety goggles or
l Pull the starter cord slowly until resistance is felt and
then pull rapidly.
NOTE: If the engine starts briefly and then shuts off,
squeeze the trigger on the spray gun to relieve the
pressure before trying to start the engine again.
l Once the engine starts, move the choke lever to the RUN
position. Allow the engine to warm up slightly before use.
STOPPING THE PRESSURE WASHER
During normal operation, use the following steps to stop
the pressure washer:
l Engage the spray gun trigger lock in the safe position.
l Move the engine OFF/ON switch to the OFF position.
l Close the fuel valve.
l Turn the water supply OFF.
l Disengage the trigger lock and depress the trigger for
15 seconds to depressurize the system.
l Disconnect the garden hose from the water inlet.
FIG. 12
A
B
C
A - Fuel lever
B - On
C - Off
FIG. 14
A
A - Recoil handle
B - On/off switch
FIG. 13
A
B
C
A - Choke
B - Run
C - Start
B
English | 13
Publicidad
