Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
NOTE: Be careful not to damage the threads on the
outlet doing so could cause the unit to leak during use.
l Gently pull on the hose to be certain it is secured.
CONNECTING A GARDEN HOSE TO THE
PRESSURE WASHER
See Figure 8.
NOTICE
Follow local regulations and
ordinances when connecting your pressure washer
to a water supply. Some jurisdictions may prohibit
you from connecting directly to public drinking
water in order to prevent the possibility of chemicals
feeding back into the system. Connections made
through a backflow preventer or receiver tank are
generally permitted.
NOTICE
The water used in this device must
come from a water main. DO NOT use this device
with water from a lake, pool, pond, etc. NEVER
use hot water with this product.
l Turn the water faucet completely off.
l Uncoil and straighten the garden hose to remove any
bends or kinks.
l Flush water through the hose for several seconds to
remove debris and then turn the faucet off again.
l Inspect the screen inside the water inlet for damage or
clogs. Clean or replace as needed. NEVER connect a
garden hose without the screen in place.
l Insert the garden hose into the water inlet.
l Thread the collar on the inlet onto the garden hose.
Tighten securely.
NOTICE
ALWAYS turn the water supply
"ON " before turning the pressure washer power
to "ON". Running the pump dry of water will cause
damage to the internal components and render the
pressure washer inoperable.
OVERVIEW
This pressure washer can produce very high levels of
water pressure and can be used for a variety cleaning
applications such as cleaning decks and walkways,
washing vehicles and equipement; and removing dirt
from home exteriors and fences.
ADDING OIL / CHECKING OIL
See Figure 9.
NOTICE
THIS UNIT HAS BEEN SHIPPED
WITHOUT OIL. Do not attempt to crank or start en-
gine before it has been properly serviced with recom-
mended oil. Failure to add engine oil before starting
will result in serious engine damage.
FIG. 8
B
A
A - Garden hose
B - Water inlet
FIG. 9
A - Oil cap/dipstick
B - Hatched area
NOTICE
Use of 2-stroke/cycle oil or other un-
approved oil types can cause severe engine damage
that is not covered under warranty.
The included, recommended oil type for typical use is 10W-
30 engine oil. If running the pressure washer in extreme
temperatures, refer to the following chart.
l On a level surface, remove the oil dipstick.
A
English | 11
B
Publicidad
