Descargar Imprimir esta página

Kalorik FT 43721 BK Manual Del Usuario página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE:
The appliance may produce an odor and/or emit smoke when
switched on for the first time, as residues from the production
process are eliminated. This is normal and does not indicate a
defect or hazard. Ensure ample ventilation.
Clean the appliance thoroughly before using for the first time
(Cleaning and Maintenance).
ASSEMBLY
See Illustrations (page 5 & 6).
Place the appliance on a clean, flat and heat resistant surface.
Before using your appliance make sure:
the basket handle (7) is locked in place in the basket (6). To lock
the basket handle (7) in place, press the bars together and slide
them between the slots. Inserting the ends of the bars into the
bracket on the basket (6) and push the handle (7) backwards
(ill. a and b). Do not assemble any other way (ill. c).
the oil reservoir (9) is secured in the correct position with the oil
filter cover (11) and oil valve (12) on the same side than the oil
filtration control knob (14) (ill. d). Ensure the oil filter cover (11) is
in place inside the oil reservoir (9).
the control panel assembly (22) is placed on the connecting
plate on the back of the housing (13). Ensure the grooves of the
connecting plate are in the guides of the control panel
assembly (ill. e).
NOTE:
YOUR APPLIANCE IS EQUIPPED WITH A SAFETY SWITCH (5)
LOCATED ON THE CONTROL PANEL ASSEMBLY (22). IF THE
CONTROL PANEL ASSEMBLY (22) IS NOT PLACED PROPERLY IN ITS
POSITION, THE APPLIANCE WILL NOT OPERATE.
Incorrect assembly may lead to an unstable setup and might
cause injuries.
The silicon rubber sealing plate (23) prevents hot steam
escaping from under the lid. Do not attempt to remove.
www.KALORIK.com
9
FT 43721 - 210607

Publicidad

loading