Skil TS6307-00 Manual Del Propietário página 51

Do not allow saw dust to accumulate inside the saw. Frequently blow out any dust that may
accumulate inside the saw cabinet, motor or blade-elevation gears. Clean your cutting tools (i.e.
blades) with a Gum and Pitch Remover. Periodically clean the guard. Wipe it or blow it clean
with compressed air. The cord and the tool should be wiped with a dry clean cloth to prevent
deterioration from oil and grease.
WARNING
ammonia, and household detergents which contain ammonia.Avoiding use of these and other
types of cleaning agents will minimize the possibility of damage.A coat of automobile-type wax
applied to the table will help to keep the surface clean and allow workpieces to slide more
freely.If the power cord is worn or cut, or damaged in any way, have it replaced immediately.
Sharpen The Teeth Of The
Antikickback Pawls
Make sure the teeth of the ANTIKICKBACK
pawls are always sharp. To sharpen:
1. Remove blade guard.
2. Rotate the pawl toward rear of spreader so
that the teeth are above top of spreader.
3. Hold the spreader with the pawl over corner
of a workbench (Fig. 73).
4. Using a small, round file (Smooth Cut),
sharpen the teeth.
Lubrication
The gear case has been completely lubricated
at the factory. However, after six months to one year, depending upon use, it's wise to return
your tool to the nearest Service Center for the following:
Brushes replaced.
•
Parts cleaned and inspected.
•
Re-lubricated with fresh lubricant.
•
Electrical system tested.
•
All repairs.
•
The following parts should be oiled occasionally
with SAE No. 20 or No. 30 oil, or WD 40
(Fig. 74).
1. Elevation rode and support rods
2. Sliding rails and supports
3. Rip-fence locking system
4. Folded stand leg joint
Certain cleaning agents and solvents can damage plastic parts . Some
of these are: gasoline, carbon tetrachloride,chlorinated cleaning solvents,
Fig. 73
Fig. 74
Sliding rails
and supports.
Elevation,
support
rods
Rip Fence
Locking Rod,
Springs
Folded
Stand Leg
Joint
51