Adjusting The Table Insert - Skil TS6307-00 Manual Del Propietário

Adjusting The Table Insert

Fig. 35
Screws
The table insert slot contains four (4)
adjustment screws for adjusting the height of
the table insert (Fig. 35). Place the insert onto
the table. Place a straight edge (such as the
metal ruler from a combination square) across
the tabletop and insert. The insert should be
slightly below the table at the front and slightly
above the table at the back.
If adjustment is necessary, use a 2.5mm hex
wrench to rotate each set screw up or down.
An improperly adjusted
WARNING
table insert can result in
Table Insert
binding which could result in personal injury.
Verify adjustments by making a dry cut before
using tool.
31