Tools Needed For Assembly And Adjustment - Skil TS6307-00 Manual Del Propietário

Tools needed for assembly and adjustment

WARNING
Fig. 4
Blade Wrenches (supplied)
Framing Square
(not supplied)
1.Position square
and draw a light line
3/4" board with
straight top edge
Disconnect the plug from the power source before performing any
assembly, adjustment or repair to avoid possible injury .
COMBINATION SQUARE MUST BE TRUE
Drawn line
Combination Square
(not supplied)
10mm Wrench
(not supplied)
No gap or
overlap
2 .5mm/5mm Hex
Wrench (not supplied)
Double-Ended Allen
Wrench, 6mm Hex,
with PH2 Phillips end
(supplied)
2.Flip square (shown in
dotted position)
3.Check edge of flipped
square against the drawn
line. There should be no gap
or overlap at the bottom end.
17