Skil TS6307-00 Manual Del Propietário página 21

3. Lower the front of the main barrier guard until the mounting fork is parallel to the table
(Fig. 13).
4. Press down on the guard-release lever until you feel and hear it snap into the locking
position. Check that the main barrier guard is securely connected (Fig. 13).
Fig. 13
Attaching the anti-kickback device
WARNING
damaged anti-kickback pawls . Dull or damaged pawls may not stop a kickback
increasing the risk of serious personal injury .
1. Press and hold the anti-kickback device lever. Align the slot in the pawls over the rear
notch on top of the riving knife (Fig. 14).
2. Release the anti-kickback device lever to snap it into place. Check that the anti-kickback
device is securely connected. Carefully raise and lower the pawls – when letting go, the
spring-loaded pawls must come down and contact the table insert (Fig. 15).
NOTE: The main barrier guard and anti-kickback device are independent of each other, so the
anti-kickback device can be attached before the main barrier guard.
Fig. 14
Guard Release Lever
Always install the anti-kickback pawls onto the riving knife with the
guard when performing "through cutting" operations . Replace dull or
Lever
1
2
Fig. 15
Pawls
21