Skil TS6307-00 Manual Del Propietário página 53

Problem
Cut not true at 90°
or 45° positions
Plastic melts or
blade tips overheat
when cutting
Tilt lock handle
elevation wheel
hard to move
Circuit Breaker
Trips
Cause
1. Alignment screws not adjusted
properly.
1. Feed rate too high.
2. Blades tip not sharp.
1. Bevel lock handle not loosened
when making tilt adjustment.
2. Saw dust on depth screw
threads.
1. Circuit breaker trips repeatedly
while cutting
Remedy
1. See "Adjustments" section,
"Adjusting Blade Parallel To
The Miter Gauge Slots."
1. Slow feed rate through blade.
2. Sharpen or replace blade.
1. See "BASIC TABLE SAW
OPERATION" section, "Blade
-Bevel Control."
2. See "MAINTENANCE"
section,"Lubrication."
1. Replace the blade with a new
blade. Reduce force applied
to workpiece during cutting.
53