Double Insulated Tools; Extension Cords - Skil TS6307-00 Manual Del Propietário

Locate the table saw in a well-lit and level area where you can maintain good footing
and balance . It should be installed in an area that provides enough room to easily
handle the size of your workpiece . Cramped, dark areas, and uneven slippery floors invite
accidents.
Frequently clean and remove sawdust from under the saw table and/or the dust
collection device . Accumulated sawdust is combustible and may self-ignite.
The table saw must be secured . A table saw that is not properly secured may move or tip
over.
Remove tools, wood scraps, etc . from the table before the table saw is turned on .
Distraction or a potential jam can be dangerous.
Always use saw blades with correct size and shape (diamond versus round) of arbour
holes . Saw blades that do not match the mounting hardware of the saw will run off-centre,
causing loss of control.
Never use damaged or incorrect saw blade mounting means such as flanges, saw blade
washers, bolts or nuts . These mounting means were specially designed for your saw, for
safe operation and optimum performance.
Never stand on the table saw, do not use it as a stepping stool . Serious injury could occur
if the tool is tipped or if the cutting tool is accidentally contacted.
Make sure that the saw blade is installed to rotate in the proper direction . Do not use
grinding wheels, wire brushes, or abrasive wheels on a table saw . Improper saw blade
installation or use of accessories not recommended may cause serious injury.

Double Insulated Tools

Double insulation
need for the three wire grounded power cord and grounded power supply system. It is a
recognized and approved system by Underwriter's Laboratories, CSA and Federal OSHA
authorities.
WARNING
WARNING
WARNING
plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. To
reduce the risk of electrical shock, do not change the plug in any way.

Extension Cords

WARNING
WARNING
overheating. The table shows the correct size to use, depending on cord length and nameplate
amperage rating of the tool. If in doubt, use the next heavier gauge. Always use U.L. and CSA
listed extension cords.
is a design concept used in electric power tools which eliminates the
Servicing of a tool with double insulation requires care and knowledge of
the system and should be performed only by a qualified service technician.
WHEN SERVICING, USE ONLY IDENTICAL REPLACEMENT PARTS.
POLARIZED PLUGS. To reduce the risk of electrical shock, your tool is
equipped with a polarized plug (one blade is wider than the other), this
Replace damaged cords immediately . Use of damaged cords can shock,
burn or electrocute.
If an extension cord is necessary, a cord with adequate size conductors
should be used to prevent excessive voltage drop, loss of power or
7