Fronius IG Instrucciones De Instalación página 11

General
Safety
ESD Guidelines
No guarantee or warranty claims can be made in respect of any improperly handled elec-
tronic component or PC board.
WARNING! An electric shock can be fatal. Danger from grid voltage and DC volt-
age from solar modules.
- All electrical installations must be carried out in accordance with the National
Electrical Code, ANSI/NFPA 70, and any other codes and regulations appli-
cable to the installation site.
- For installations in Canada, the installations must be carried out in accor-
dance with applicable Canadian standards.
- The connection area should only be opened by an authorized electrician.
- The power stage set area should only be opened by Fronius-trained service
technicians.
Never work with live wires! Prior to all connection work, make sure that the AC
and DC wires are not charged.
WARNING! An electric shock can be fatal. Danger from residual voltage from ca-
pacitors.
You must wait until the capacitors have discharged. Discharging time lasts 5 min-
utes.
Using a suitable measurement device, ensure that the capacitors have fully dis-
charged.
WARNING! Incorrect operation and work performed incorrectly can cause seri-
ous injury and damage! Only qualified staff are authorized to install your inverter
and only within the scope of the respective technical regulations. Do not start op-
eration or carry out servicing and repair tasks before you have read the chapter
"Safety Instructions."
NOTE! Observe ESD guidelines when handling electronic components and PC
boards. This primarily applies to ESD-compatible
- Packaging
- Work surfaces
- Floors
- Seating
- Grounding options
- Handling
9