Publicidad
Idiomas disponibles
Idiomas disponibles
4 USING THE VACUUM CLEANER
4.1 WORKING WITH DUST BAGS
If sucking up dry dust an optional dust bag can be used to collect the dust and ease the disposal.
To insert the dust bag take off the head (see also fi gure 3). Insert the dustbag like shown on
fi gure 6A. Put on the head again and secure the head with the clamps
Fig. 6A
For Dust Class M dustless emptying is required and thus a Dust bag or similar should be used
For Dust Class H machine dust
free emptying is required. Use
the special safety dust bag
as on fi gure 6b. Fit the plastic
fi tting part of the dust bag onto
Fig. 6A
the fi tting inside the tank.
Make sure it is properly fi xed.
Wrap the plastic bag over the
edge of the tank. Make sure
Fig. 6B
the hole to equalized the pres
sure are located inside the tank
4.2 DRY OR WET FLOOR SUCTION
To suck up dry dust and debris use the dry fl oor nozzle
(A) with the bristles rim.
To suck up wet debris replace the brush rim with a
screwdriver and insert the rubber squeegees
Fig. 7
4.3 VACUMING - INSERTING AND
REMOVING THE HOSE
To vacuum insert the hose (A) into the suction inlet
(B).
To remove the hose twist and pull in one movement
to remove (C)
Fig. 8
4.4 BLOWING (ONLY DUST CLASS L) -
INSERTING AND REMOVING THE HOSE
The machine can also be used for blowing.
To use the blow function insert the hose into the blow outlet (A) in
the same way for the suction inlet. See above. The blowing can be
controlled by the lever (B)
Fig. 9
en - 29
Publicidad
