Publicidad
Idiomas disponibles
Idiomas disponibles
4.5 TURNING THE MACHINE ON
The machine is turned on/off by pressing the start/ stop button (A)
The machine can optionally be equipped with LEDs with power
control (C). By turning the knob the suction of the machine can be
controlled. The suction performance is also shown by the LEDs.
If equipped with LED the 1st LED from left, when the machine is
plugged in, will be ON.
To use the optional socket (B) see next chapter.
The machine can optionally be confi gured with an indicator (D). The
indicator goes on, when the underpressure is high. This can be due to
the fi lter being clogged and needs to be cleaned (see later chapter) or
the bag/tank is full and need to be replaced/emptied
Fig. 10
4.6 MACHINE WITH SOCKET AND AUTO START/STOP (OPTIONAL)
The machine can optionally be equipped with a socket
that can be used in connecting with a power tool.
Connect the power tool to the socket (A). Remove the
handtube and fi x the conical adapter (B). Insert the
conical adapter to the power tool (C). Turn the machine
to AUTO mode with the switch (D). The machine will then
start, when the power tool is turned on and stop with a
delay (in order to empty the hose) when the power tool
is turned off
Fig. 11
! WARNING - Do not operate without fi lter basket and fl oat, as they prevent liquid from entering the impeller and damaging the motor. Do not
suck up any liquids without a sponge fi lter installed.
! WARNING - Only use the socket on the machine for the purposes specifi ed in the instructions..
NOTE: IF ACCIDENTALLY TIPPED OVER, THE VACUUM COULD LOSE SUCTION. IF THIS OCCURS, PLACE VAC IN UPRIGHT POSI-
TION AND TURN SWITCH OFF. THIS WILL ALLOW THE FLOAT TO RETURN TO ITS NORMAL POSITION, AND YOU WILL BE ABLE TO
CONTINUE OPERATION.
! WARNING - Read the Safety Warnings and Instructions concerning the types of wet materials that cannot be vacuumed with this product.
! DANGER - This equipment incorporates parts such as switches, motors or the like that tend to produce arcs or sparks that can cause an
explosion. Do not pick up fl ammable, combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fi re or explosion.
This vacuum cleaner has a built in thermal overload protector to protect the motor from high temperatures. This can occur under heavy use.
If the motor temperature shuts off during operation, turn the switch off and allow the motor to cool for 10 minutes. Turn switch on and resume
operation.
30 - en
Publicidad
