Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
English
2. Use suspension screws for installation
Investigate whether the installation site can support the mass of the indoor unit, and if necessary, hang
the indoor unit with screws after it is reinforced by beams, etc. (Refer to the installation pattern paper for
the mounting step).
3. Ceiling height
This indoor unit can be installed up to 4.3m for packing size (1675*770*320mm) and up to 3.5m for
others.
Please do not pull out the product and the horizontal flap of the air outlet and air inlet.
Do not lift the product or pull it by its cover (right and left). When the cover is bent, it may cause noise.
4. Prepare before installation or the locations of the indoor unit's suspension screws, pipe outlet holes,
drain pipe outlet hole and electrical wiring inlet hole.
electrical wiring entry hole.
1. Removing parts of the indoor unit
- Slide back the handles of the suction grille (as indicated by the
arrow) to open it wide.
Fijación
- Holding the suction grille open, grasp the handle on the back of
the suction grille and, at the same time, pull it
the back of the suction grille and, at the same time, pull it forward
to remove it.
- After removing the grille, screw the bottom cover screws as
shown.
97
infiniton.es
Publicidad
