Publicidad
•
Take the compactor to where it is required.
Where it is necessary to use lifting equipment to position the compactor, make sure the lifting equipment has a WLL (Working
Load Limit) suitable for the compactors weight (see Technical Data section or the machine serial plate). Attach suitable chains
or slings ONLY to the lifting point on the top of the compactor.
•
Having carried out the checks listed in the 'Pre start' section, you may start the engine.
The Altrad Belle 'RPC' range of compactors are tted with a centrifugal clutch, this allows the engine to run at idle without driving
the gearbox.
As the engine speed is increased the clutch will engage and will drive the gearbox. For correct operation, the engine speed
should be set to maximum.
•
Set the throttle to maximum and use the control handle for direction and to steer or turn the compactor.
The control handle has been designed so that when it is being used in reverse and the operator lets go for any reason, the
handle automatically moves into forward mode. This is a signi cant safety feature of the machine.
During normal operation you should not have to push the compactor but allow it to travel at its own pace.
The speed of travel will be determined by the condition of the surface being compacted.
Caution must be used when operating the compactor in reverse. Ensure that there are no obstructions or trip hazards when
operating in reverse.
If the surface to be compacted is on a slope, great care must be taken when controlling the compactor's direction of travel. If
necessary, use a suitable rope attached to the compactor at a low point on the chassis, to allow a helper to take part of the
compactor's weight. Work up and down a slope not across.
•
Work the compactor over the surface in an organised pattern until the required compaction has been achieved.
Where there are a number of different layers to be compacted on top of each other, compact each layer individually.
•
To stop the compactor vibrating, set the throttle to idle. To stop the engine refer to the relevant start / stop procedure.
Problem
Engine will not start.
Engine still will not start.
Unit will not move.
Forward speed too slow.
Reverse speed too slow.
Loss of Hydraulic Oil.
Machine operates
erratically.
Operating Instructions
Trouble Shooting Guide
Cause
No fuel.
Engine switched off.
Spark plug fouled.
Engine cold.
Engine ooded.
Major Fault.
Engine speed too slow.
Drive belt tension loose.
Air lter blocked.
Worn or Damaged Clutch.
Drive failure.
Gearbox failure.
Too much oil in hydraulic head.
Wrong adjustment of control system
Not enough oil in hydraulic head.
Air in control system.
Wrong adjustment of control system
Connectors leaking.
Defective hydraulic hose.
Piston seal in gearbox defective.
Shock mounts damaged.
Remedy
Open fuel tap.
Fill fuel tank.
Switch engine on.
Clean and reset plug gap.
Close choke.
Honda, open choke, fully open throttle, pull recoil starter
until engine res.
Hatz, move speed control to stop, pull recoil starter 5 times
then repeat start procedure.
Contact Agent or Altrad Belle.
Set engine speed control to fast.
Adjust belt tension
Clean or renew air lter.
Repair or Replace as necessary.
Contact Agent or Altrad Belle.
Contact Agent or Altrad Belle.
Reduce oil level.
Contact Agent or Altrad Belle.
Fill and bleed system.
Bleed control system.
Contact Agent or Altrad Belle.
Reseal connectors.
Replace hose.
Contact Agent or Altrad Belle.
Replace all four mounts.
17
Publicidad
