SPM GT1 Touch Manual De Uso Y Mantenimiento página 57

- When machine is switched on, the main
selection menu turns up; you can enter the
preparation phase of each product by selecting
one of the corresponding key (for example ICE
CREAM) and the unit will start working with
these pre-set parameters.
If the unit is not operating after selecting one of
the product buttons, check the cover
positioning, GT is equipped with a very efficient
safety mechanism, if the main cover is not
correctly positioned, GT will not work.
The unit functioning could be divided into
different phases; each one of these has its own
parameters such us rotation speed, duration
and temperature pre-set.
PRODUCT PREPARATION
"PREPARATION" PHASE
The purpose of this phase is to mix and to
prepare the product in order to reach the right
consistency and the right temperature.
In the low and right side of the touch screen
you can see two buttons:
"DISPENSING"
You can enter the dispensing phase by selecting
the corresponding key. The motor runs at the
pre-set speed for dispensing and for a pre-set
timing that varies relating to product.
The dispensing key has the aim to increase the
motor speed to help the extraction of the
product.
During preparation phase, you will read "--------
--" on the "DISPENSING" key; this means that
the product is in preparation and not ready for
dispensing and use (fig.8).
Also during the preparation phase, when you
can see "----------", the dispensing button is
working; if you switch it during the preparation
phase, the preparation phase is interrupted and
the machine, after dispensing, turns into
conservation phase. This operation is useful in
case of switching off and again on, in order to
bypass the preparation phase period.
Data di emissione: Dicembre, 2013
!NOTE!
DEFROST key
Revisione: 5
Fig. 7
DISPENSING key
Fig. 8
Pag. : 57/124