Positioning - SPM GT1 Touch Manual De Uso Y Mantenimiento

Data di emissione: Dicembre, 2013
Fig. 1
Fig. 2

6. POSITIONING

FOR MAINTENANCE WORKER ONLY
The installation and subsequent servicing
operations must be carried out by skilled
members who have been trained to use the
device and
regulations in force.
a) Remove the packing (fig.1) and preserve it
in order to reuse for winter storage.
All the parts of the packaging must be kept
beyond the range of children, as they might
represent a potential safety/health risk.
b) Make sure
condition.
b) Rest the machine on a sturdy, flat surface
making sure it is well ventilated by leaving a
gap of 20 cm around it and do not install it near
heat sources (fig.2); we recommend you to
maintain a room temperature between 24
and 32°C.
c) Check that the power mains voltage meets
the specifications
identification plate and that the output available
meets the device's power requirements.
Fit the plug into an earthed socket, removing all
multiple adaptors.
FOR FURTHER PRECAUTIONS, READ THE
SECTION "CONNECTION TO THE ELECTRICITY
MAINS" CAREFULLY.
d) The installation must be carried out in
accordance with the manufacturer's instructions.
Failure to comply with the positioning and
installation instructions
machine's operation.
You are legally required to provide a suitable
grounding system for the equipment.
Before carrying out any cleaning and/or special
maintenance on the device, make sure it is
disconnected from the mains by unplugging it.
In the event of a breakdown or malfunctioning,
switch off the device and remove the plug.
Revisione: 5
in compliance
Caution
the machine is
on the
may impair
Important
Pag. : 54/124
with the
in perfect
equipment
the