SPM GT1 Touch Manual De Uso Y Mantenimiento página 65

- Unscrew the security knob in the direction of
the arrow (threading on left), then pull out the
mixing unit, the bell shaped seal and the bowl
gasket on the back (fig.29).
- Remove the drip tray by pulling it outward
(fig.30).
- Thoroughly wash all the removed components
with hot water and dish washing, but do not use
abrasive detergents or powders that can
damage the bowl.
IMPORTANT
Do not use too aggressive sanitizers or
detergents, these kind of products could
damage the bowl and the other
components.
CAUTION
Never perform these washing operation
with a dish washing machine; failure to do
so could seriously damage the unit's parts.
- Rinse well and then place all the components
in the sanitizer solution; for proper sanitizing
the parts must remain fully plunged for 15
minutes or as recommended by the sanitizer
manufacturer.
- After respecting the correct sanitizing period,
rinse well all the components with clean water
and dry them up with a clean cloth.
- Thoroughly wash the evaporator and the drip
tray surfaces with a sponge soaked with the
sanitizer (see fig.31).
- Repeat all these operations with a clean
sponge soaked with water and carefully dry up
all the surfaces with a clean cloth.
Data di emissione: Dicembre, 2013 Revisione: 5
Fig. 29
Fig. 30
Fig. 31
Pag. : 65/124