Important Warnings And Advices; Equipment Kit; Tranport Tips; Lifting Tips - SPM GT1 Touch Manual De Uso Y Mantenimiento

1. IMPORTANT WARNINGS AND
ADVICES
This installation and operation manual is
an integral part of the equipment and must
be kept for future consultation.
Unless otherwise stated, this manual is
addressed to operators (staff members
who uses the equipment on a daily basis)
and to servicemen (staff members qualified
to carry out the
maintenance). The parts of the manual
addressed only to servicemen are pointed
out accordingly. Please read carefully the
warnings listed
installation and start-up of the equipment.
This equipment
produce soft serve ice cream, ice milk,
frozen yogurt,
frozen dairy products.
Upon receipt of the equipment, make sure
that its part number matches the one
specified in the order, which can be found
on all the delivery documents.
This equipment is exclusively destined to
the purpose for which it was designed. The
manufacturer cannot be held responsible
for any damage due to improper use.
This equipment is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, without
supervision or instruction concerning its
use by a person responsible for their
safety. Children should be supervised to
ensure that they do not play with the
machine.
This equipment is not suitable for outdoor
use. This machine
installation in locations where water jets
are used. This equipment must be installed
in places where it can be controlled by
qualified staff.
Data di emissione: Dicembre, 2013
installation
here below
has been designed
smoothies and
is not suitable

2. EQUIPMENT KIT

In the packaging of this equipment you will find
also:
- operator's manual,
- 1 tube of Vaseline grease lubricant to be used
for machine maintenance;
- EC declaration of conformity;
- 1 drip tray.
and/or

3. TRANPORT TIPS

before
To prevent
compressor running into the cooling circuit, the
to
device must be carried, stored and handled in
the upright position, following the direction
similar
instructions on the packing. If the device is
accidentally or intentionally (for transportation
reasons) kept in any other position, it must be
set again in the correct position at least twenty
minutes before start-up procedures, in order to
let the oil flow back into the compressor.

4. LIFTING TIPS

Each machine is equipped with a special wooden
pallet that allows the handling with standard
forklift trucks.
Never lift the machine alone, but always seek
the assistance of another operator.
To prevent and avoid any damage to the
machine, all loading and unloading operations
for
should be carried out with special care. The
equipment can be lifted, with either a manual or
engine-powered lifting truck, by positioning the
forks in the base section of the unit.
The following operations should always be
avoided:
- to turn upside down the machine;
- to drag the machine with ropes or others;
- to lift the machine with slings or ropes
- to shake or rattle the machine and its
packaging.
Revisione: 5
the oil held in
Caution
Pag. : 52/124
the hermetic