Arneg Ginevra 2 Serie Manual De Instalacion Y Uso página 36

Ginevra 2
English
use chemical substances on the stainless steel that contain 25% of nitric acid or
similar substances.
Die-hard stains and rust:
sandpaper or polish with a stainless steel brush. After this operation, wash with
detergents and carefully dry. This intervention may however cause scratches to the
surfaces due to the abrasive cleaning method.
21_9.Cleaning aluminium parts
DO NOT use acid or alkaline detergents (e.g. bleach) which could corrode the
surfaces
DO NOT use rough or abrasive materials or metal scrapers that could scratch
the aluminium surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
Use a soft cloth with a neutral detergent or soap and lukewarm water (max
30°C).
Immediately remove all traces of water or detergent using a dry cloth in order
to prevent marks from forming.
All the cleaning operations, including the disinfection, the rinse and the drying
must be performed diligently, eliminating any water or detergent residue so as to
avoid the spread of bacteria harmful to health. Parts left to dry with detergent or
disinfectant residues may get damaged.
Remove any element from the pavement such as: sponges, rags, detergent or
water residues that may cause accidental slipping and falls.
21_10.Inspection of the parts
Once cleaning, disinfection, rinse, and drying operations have been completed,
accurately check that all the parts are perfectly clean and dry and that they are not
damaged or excessively worn out and, if need be, replace them.
Reassemble the completely dry elements and restore electrical power supply. Once
the internal operating temperature has been reached, it is possible to load the products
to be displayed in the cabinet.
22.Dismantling the cabinet - specialized technician -
The cabinet must be dismantled in compliance to the norms that concern the handling
of wastes foreseen in the individual countries, and in respect of the environment in
which we live in. This product is considered by the Legislature in force to be a
dangerous waste and therefore its separate waste collection is obligatory and it cannot
be treated as domestic waste nor assigned to a waste dump. Before dismantling the
cabinet, it is necessary to provide for the recovery of the refrigerant and to remove the
lubricant oil. This product is made up by 75% of recyclable materials.
Materials used in the manufacture:
- Stainless steel 18/10 (AISI 304):various finishings
- Iron pipe sections:
- Copper, Aluminium:
- Galvanized steel sheet:
- Plasticized galvanised steel sheetexternal and internal sheet
- Tempered glass:
- Expanded polyurethane (CO
- ABS
- PVC:
36
bottom frame
refrigeration circuit, electrical system, various
finishings
lower motor, lower panels, painted panels
perimeter windows
):heat insulation
2
lateral shoulders
shock absorbed sections, defrosting water drain pipe,
inside tank
05060155 00 28/11/2013